Festo CPV -VI Series, Manual

Page: 46 / 118

2.2 CPV valve terminal with pneumatic multiple connector plate
If you are using a pneumatic multiple connector plate,
the power supply and work lines will be connected at a
central point. This enables the supply and work lines to
be disconnected from the CPV valve terminal easily
and quickly.
PLEASE NOTE
Only CPV valve terminals, which have been fitted
with appropriate end plates, may be mounted on the
pneumatic multiple connector plate.
CPV valve terminals, which have been fitted with
end plates for individual tubing, can be converted
before they are fitted onto the pneumatic multiple
connector plate.
In this case replace the end plates with multiple
connector end plates.
The pneumatic multiple connector plate is available in
two variants:
– Standard design of the pneumatic multiple connector
plate which fits flush with the end plates of the CPV
valve terminal. The holes for fastening the valve ter-
minal onto a wall or for mounting on feet are on the
same side as the connections on the pneumatic mul-
tiple connector plate.
– Extended pneumatic multiple connector plate which
projects over the end plates. Due to its external fa-
stening bores, this plate can be fitted very easily.
Two additional holes running transversely through
this pneumatic multiple connector plate enable the
valve terminal to be fitted by the rear to a wall (see
chapter "System summary" Fig. 1/2).
2. Fitting
2-16
CPV... 9811d