Festo Checkbox Identbox, Manual

Page: 16 / 158

Contents and general instructions
XIV
Festo P.BE-Checkbox-EN en 0103c
Documentation on the Checkbox family
Further information on using the Checkbox can be found in
the following manuals:
Manual Contents
User manual on the Checkbox family,
type P.BE-Checkbox... Description of the functioning, commissioning,
operation and maintenance of the relevant Check-
box type: Identbox, Countbox and Sortbox
Description of the Checkbox configurator
software package, type P.SW-CB-KONF-... Operation of the CheckKon software package
(Checkbox configurator)
Description of the Checkbox optimizer
software package, type P.SW-CB-OPTI-... Operation of the CheckOpti software package
(Checkbox Optimizer)
Product-specific terms and abbreviations
Term/abbreviation Meaning
Bad part A test part on which at least one feature lies outside the tolerances.
C-value The C-value indicates the extent of the scatter of the features of the
sample parts.
Checkbox Any device from the Checkbox family (e.g. Identbox, Countbox,
Sortbox).
Feature Characteristic features are ascertained from the contour data of the
sample and test parts. These are, e.g. length, height etc., as well as a
feature for each configuration tool (CheckOpti).
Good part A test part on which all features lie within the tolerances.
Orientation The parts to be checked by the Checkbox may lie facing in different
directions on the conveyor belt. During the teach procedure, you de-
fine the orientations by showing the part in different directions.
Orientation 1 is the preferred orientation (nominal orientation).
Parts type Conveyed part defined by the teach data of the sample parts.
Sample parts Parts shown during the teach procedure.