Festo CESA-GW-AS-CO, Installation And Operation Manual, Page: 38 / 83

CESA-GW-AS-CO Description
38
6.8.2 FORCE OFFLINE (Switch AS-i Master to offline operation)
Main menu || SETUP || FORCE OFFLINE ||
This function is used to change the address of a slave.
With "Change", this status can be changed.
Switching the AS-i master to offline operation puts the AS-i network into the safe
state. The AS-i master must be offline if an AS-i slave needs to be readdressed
via the IR-interface.
6.8.3 OPERATION MODE
Main menu || SETUP || OPERATION MODE ||
This function shows the current operation mode of the AS-i master:
The operation mode can be changed with “Change”.
Parameters and configuration data can be modified in configuration mode, only.
6.8.4 STORE ACTUAL (store currently detected configuration)
Main menu || SETUP || STORE ACTUAL||
This function can only be executed in configuration mode.
This function enables currently detected slaves on the selected AS-i network to
be stored in the configuration of the AS-i Master.
If "Store" was successful, the LED "Config error" is turned off. The configuration is
stored and the configuration error has been eliminated.
However, if one of the connected slaves exhibits a peripheral fault, the LED "Con-
fig error" will flash.
FORCE OFFLINE
NO
CHANGE
YES: AS-i Master is offline.
NO: AS-i Master is online.
OPERATION MODE
CONFIG MODE
CHANGE
PROTECTED MODE: protected operating mode
CONFIG MODE: configuration mode
STORE ACTUAL
CONFIGURATION
STORE