Festo CESA-GW-AS-CO, Installation And Operation Manual, Page: 35 / 83

CESA-GW-AS-CO Description
35
6.7 SLAVE TEST TOOL
Main menu || SLAVE TEST TOOL ||
After selecting the menu SLAVE TEST TOOL a warning message is displayed,
pointing out, that it is possible during this test that outputs are set and that the
host may loose control over the network.
Pressing the OK button continues with the actual test, ESC cancels the process.
In the proceeding menu the slave to be tested has to be selected by entering the
slave address.
Afterwards, testing the selected slave is started by confirming the menu entry
"Test".
After finishing testing the selected slave all relevant information is displayed. A
successful test is indicated by "OK" below the address of the tested slave.
The following information is displayed:
•
Address of the tested slave
• Display of a configuration error (if present)
• Binary inputs (digital inputs)
• Binary outputs (digital outputs)
• Analog inputs
Failed: SE: error setting new address for AS-i slave.
Failed: AT: new address for AS-i slave could be stored temporarily only.
Failed: RE: error reading extended ID1-code.
Failed: SND: slave with old address has not been detected.
Information!
When working with a double master (AS-i master and two AS-i networks) the AS-i net-
work must be selected first by using the arrow and the OK buttons.
AS-i CIRCUIT 1
AS-i CIRCUIT 2
WARNING:
OUTPUTS MAY BE
SET AND HOST MAY
LOOSE CONTROL.
SLAVE TEST TOOL
SLAVE ADR 21A
TEST