Ferm AGM1116P, Original Instructions Manual

Page: 9 / 180

9
EN
Fig. C2 & D2
Protection guard for cutting (not included)
Fig. G
16. Screw
17. Spring
18. Carbon brush
19. Brush wire
Assembly
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Assembling the protection guard (Fig. C and D)
• Place the machine on a table with the spindle
(11) facing upwards.
• Place the protection guard (3) over the
machine head as shown in Figure C making
sure the ridges on the protection guard fall into
the notches of the machine head.
• Turn the protection guard counter clockwise as
shown in Figure D
• Fix the the allen screw (2) on the guard (3) with
the allen key (8)
• You can adjust the position of the protection
guard by releasing the allen screw (2), adjust
the guard to the desired position and fixing the
allen screw again.
Never attempt to remove the guard.
Mounting and removing the disc (Fig. B)
• Always use suitable wheel disc for this
machine with diameter AGM1116P Ø 180mm
/ AGM1118P Ø 230mm and a bore from 22.2
mm the thickness of the wheel disc should be
6 mm for wheel disc for grinding and 3 mm for
wheel disc for cutting, the mounting wheel disc
may not touch the safety guard.
Mounting
• Place the machine on a table with the
protection guard (3) facing upwards.
• Mount the flange (12) onto the spindle (11).
• Place the wheel disc (13) onto the spindle (11).
• Keep the spindle lock button (1) pressed and
firmly tighten the clamping nut (14) onto the
spindle (11) by using the spanner (15).
Removing
• Place the machine on a table with the
protection guard (3) facing upwards.
• Keep the spindle lock button (1) pressed and
loosen the clamping nut (14) using the spanner
(15).
• Remove the wheel disc (13) from the spindle
(11).
• Keep the spindle lock button (1) pressed and
firmly tighten the clamping nut (14) using the
spanner (15).
Mounting the side handle (Fig. A and B)
• The side handle (7) can be screwed into one of
the three side handle connection point (6).
3. OPERATING
Make sure that the work piece is properly
supported or fixed and keep the supply
cord routing away from the work area.
Rear handle
Before rotating the handle, always switch
off the machine and remove the mains
plug from the mains.
1. To unlock the handle (9), push and hold the
handle release knob (10).
2. Rotate the handle (9) into one of the 5 available
positions and release the handle release knob
(10).
Before switching the tool on, ensure the
handle release knob (10) clicks and locks
into place when changing handle position.
Switching on and off (Fig. A)
• To switch the machine on, push the switch
forward and press the On/off switch (5).
• To switch the machine off, release the On/off
switch (5).
Hold the machine away from the work piece when
turning it on and off because the wheel disc could
damage the work piece.
• Clamp the work piece firmly or use another
method to ensure that it cannot move while
working.
• Check the discs regularly. Worn wheel discs
have a negative effect on the machine’s