27
HNC3 825 / HNC3 825 perform
Technical information
●
WARNING: The noise emission values stated are not exposure level values.
●
Although there is a correlation between emission and exposure levels, the
emission values can not be used to reliably determine whether increased
safety measures are required.
●
Factors that influence the actual degree of exposure are the actual work
process, the exposure time, the characteristics of the workplace and other
neighbouring noise sources in the workshop.
●
To keep the noise emission as low as possible, always use sharpened tools
and operate the machine at the correct speed.
●
The machine's maintenance and the type of workpiece to be processed also
affect the noise emission.
●
Ear protection must always be worn; however, such protection cannot be
considered a substitute for properly sharpened tools or the correct speed.
●
The machine operator should find out about the normal level of noise emis-
sion and be attentive to any changes.
●
A different level of noise emission can be due to a defect.
●
If the stated noise emission values are to be checked, then the measurements
must be taken following the same procedure and in the same operating and
installation conditions as described.
Summary of Contents for Hammer HNC3 825
Page 69: ......