26
Technical information
4.6
Dust emission
The working areas of this machine are considered dust-minimised according to
DGUV Information 209-044. The maximum concentration level of 2 mg/m³ of
inhalable dust in the air will not be exceeded. This only applies if the conditions
that are specified in the section "Extraction" are adhered to.
4.7
Noise emissions
Note on measurement
Testing of the stated noise emission values
If the stated noise emission values are to be checked, then the
measurements must be taken following the same procedure and in
the same operating and installation conditions as described.
All values in dB(A) and with a measurement uncertainty factor of 4 dB(A). Meas-
urement conditions and additional information according to ISO 19085-1:2021,
chapter 6.2.2.
The measurements are carried out in accordance with the following standards:
●
EN ISO 3746, acoustic power level
●
EN ISO 11202, workplace emission values
HNC3 825 (without tools)
Idle*
Noise level
65 dB (A)
Measurement tolerance
4 dB (A)
*Machine measured values, noise emission HFM see separate operating manual.
HNC3 825 perform
This measurement was taken whilst the machine was idling without tool.
Idle
Noise level
82 dB (A)
Measurement tolerance
4 dB (A)
●
WARNING: The noise emission values stated are only valid, when the same
operation and installation conditions apply.
●
Other operation and installation conditions, e.g. a different work process,
can lead to higher noise emission values with the danger of underestimation.
Summary of Contents for Hammer HNC3 825
Page 69: ......