53
HNC3 825 / HNC3 825 perform
Maintenance
1
2
3
Fig. 32: Lubricating nipple X-axis left side
1 Slot
2 Lubricating nipple X-axis
3 Lubricating nipple guiding carriage
2.
Position the portal in such a way that the lubrication nipple on the left side is
in the recess.
CAUTION! Open, rotating drive spindles. Do not reach into the area of the
open spindle covers.
3.
Switch off the machine at the main switch, disconnect the power supply.
4.
Remove dirt or grease.
5.
Clean all lubricating nipples.
6.
Place the pressure grease gun onto the nipple and pump 3 times.
🡆
A small amount of lubrication will come out of the seals.
7.
Lubricate all (6) lubricating nipples.
8.
Attach cover.
9.
Switch machine on.
10.
Move several times over the entire length of the axle to distribute the grease.
🡆
Axis is covered with a thin film of grease.
Lubricate Y-axis
The Y axis lubrication nipple, is situated at the rear side of the machine on the
portal.
Summary of Contents for Hammer HNC3 825
Page 69: ......
