Felder AD 941, Operating Manual

Page: 66 / 72

66
Planer-Thicknesser
A 941 / AD 941 / AD 951
11.7.4 Possible application errors and solutions
11.7.5 Spare parts
Improper operation may cause increased ripples or stronger longitudinal grooves on the planed surface. These may
be caused by the following:
1. Improper cleaning of the pockets when changing
cutters/inserts.
2. Improper cleaning of the carbide inserts (resin- or dust
residues on the carbide inserts when changing them).
3. Ensure that the carbide inserts are aligned correctly
and are placed into the pocket at the correct angle
prior to tightening the clamping screw.
4. Under or over-tightened clamping screws.
5. Damaged pocket due to improper insertion and
tightening of the carbide insert.
6. Damaged clamping screw.
7. Changing one single carbide insert. All carbide
inserts should be changed or turned to the next mark
simultaneously.
8. Changing or turning just only one of the carbide
inserts because of damage may create a small gap in
the planed surface at this position.
Only use genuine Felder-Group carbide inserts due to their specific geometry. Due to safety reasons only use genuine
Felder-Group clamping screws for carbide inserts.
Art. No. Description
07.0.020
HW replacement blades for Silent-POWER® spiral knife cutterblock
13.8x13.8x2.5 mm, (10 Quantity)
07.0.02050
HW replacement blades for Silent-POWER® spiral knife cutterblock
13.8x13.8x2.5 mm, (500 Quantity)
07.0.022
HW replacement blades for Silent-POWER® "c-tech" spiral knife cutterblock
13.4x13.4x2.5 mm, (10 Quantity)
07.0.021
Replacement screws for Silent-POWER® spiral knife cutterblock
M5x10 TX20, (10 Quantity)
12.0.324 Torque wrenches 5 Nm
10.0.022 Resin remover 500 mL
Faults