40
Planer-Thicknesser
A 941 / AD 941 / AD 951
9 Operation
9.1 Safety instructions
Note: Accessories:
When planing, additionally support workpieces that are longer than the feeder- and receiver-sides (by using
e.g. table extensions, roller supports)
Keep tools for handling short and narrow workpieces close at hand. (e.g. wooden pushing stick, push block)
Warning! Risk of injury! Improper operation may lead to severe physical injury or material damage. For this
reason, this work may only be carried out by authorised, trained personnel who are familiar with how to
operate the machine and in strict observance of all safety instructions.
Before starting work:
• Before commencing any work with the machine,
inspect it to ensure that it is complete and in
technically good condition.
• Ensure that there is sufficient space to work around
the machine.
• Keep the work area orderly and clean. Components
and tools that are not put in their correct place or put
away may be the cause of accidents!
• Ensure that all the planer knives are sharp (minimises
the kickback risk).
• Ensure that all clamping screws on the knife holders
are securely tightened (minimum tightening torque:
20 Nm).
• Ensure that the individual kickback guards are free to
move and that they fall back into their initial position
after having been raised.
• Install the dust extraction system according to the
instructions and test its function.
• Only machine workpieces that can be safely placed
on the machine and guided.
• Carefully inspect workpieces for foreign matter (nails,
screws) which might impair processing.
• Ensure that the tool turns freely.
• Ensure the cutterblock direction of rotation is correct.
• Before switching on the machine, always check to
make sure that there are no other persons in the im-
mediate vicinity of the machine.
During operation:
• When changing to another workpiece or if a
malfunction occurs, first switch off the machine and
then secure it against being switched on again
accidentally.
• Do not switch off, circumvent or decommission
protective and safety devices during operation.
• Risk of injury due to ejected work pieces and parts of
work pieces (e.g. branches, chips).
When working on or with the machine, the following
must be strictly observed:
• Persons with long hair who are not wearing a hairnet
are not permitted to work on or with the machine!
• It is prohibited to wear gloves while working on or
with the machine.
When working on or with the machine, the following
must always be worn by personnel:
• Sturdy, tight-fitting clothing (tear-resistant, no wide
sleeves, no jewellery (rings, bracelets, necklaces,
etc.)).
• Protective footwear - To protect the feet from heavy
falling objects and prevent sliding on slippery floors
• Hearing protection - To protect against loss of hea-
ring
Warning! Risk of injury from workpieces or other workpiece parts jamming in the machine or being ejected.
Therefore never stand directly within sight of the machining units when the machine is operating (whether the
machine is working or on stand-by mode)!
Operation
Summary of Contents for AD 941
