SmartSiren Platinum Convergence Network
Federal Signal www.fedsig.com
Mounting the Siren and Control Head
40
Figure 22 Slots for mounting hardware
1.05 in
(2.66 cm)
7.49 in
(19.03 cm)
7.94 in
(20.17 cm)
4.50 in
(11.43 cm)
Mounting Slots
(4 Places)
Installer-Supplied
#10-32 Mounting
Hardware Required
290A7560
2. Tap and drill the center of the four mounting holes.
3. Center the slots in the base of the siren amplifier/relay module over the drilled
holes and secure it with the installer-supplied #10-32 mounting hardware.
Mounting the Control Head
The control head comes with two mounting brackets and mounting hardware.
Tools needed:
• Drill with #9 drill bit
• Phillips screwdriver
• 7/16-inch nut driver
• Pencil or felt-tip pen for marking drill position locations
To mount the control head:
1. Secure a bracket to the control head with the 6-32 by 1/4-inch Phillips screws and
#6 lock washers. See Figure 23 on page 41.
2. Using a 7/16-inch nut driver, secure the other bracket to the control head/
bracket assembly with the 1/4-20 by 3/4-inch hex head screws and 1/4-inch lock
washers. See Figure 24 on page 41.
3. Use the mounting bracket as a template and scribe two drill position marks at
the selected mounting location.
