Mounting the Siren and Control Head
41
Installation and Maintenance Instructions
Federal Signal www.fedsig.com
Figure 23 Bracket attached to back of control head
Net
work
Connect
ion
Only!
A
Non-net
work
Connect
ion
Will
Result
In
Damage
To
Devices.
Do
Not
Connect
T
o
Pc.
For
Furt
her
Inf
ormat
ion
See I
nstruct
ions
Or
Call
1-800-433-9132.
Pc
Connect Only
!
Warning
290A7561
Control Pad
Bracket (1 of 2)
Note: Use one of the three
sets of holes in the pivot
bracket to best position
the control pad.
#6-32 X 1/4" Screw,
Phl. Pan Hd (2)
PEM
®
Nut
(Attached to Bracket)
#6 Split Lock Washer (2)
DRILLING PRECAUTIONS: When drilling holes, check the area you are
drilling into to ensure that you do not damage vehicle components while
drilling. All drilled holes should be de-burred, and all sharp edges should be
smoothed. All wire routings going through drilled holes should be protected
by a grommet or convolute/split loom tubing.
4. Drill two pilot mounting holes at the drill position marks.
5. Secure the mounting bracket to the mounting surface with the #10 thread-
forming screws. See Figure 24.
6. To adjust the angle of the control head, loosen the hinge screws, tilt the control
head forward or backward, and then securely tighten the screws.
Figure 24 Brackets attached to control head and mounting surface
Net
work
Connect
ion
Only!
A
Non-net
work
Connect
ion
Will
Result
In
Damage
To
Devices.
Do
Not
Connect
T
o
Pc.
For
Furt
her
Inf
ormat
ion See
Inst
ruct
ions
Or
Call 1-800-433-9132.
!
Warning
290A7562
Pilot Holes (2)
PEM
®
Nuts (Attached To Bracket)
Bracket (2 Of 2)
Mounting Surface
Mounting Holes
#10 Screw,
Thread-forming (2)
1/4-20 X 3/4" Hinge Screw,
Hex Head (2)
1/4" Lock Washer,
Ext. Tooth (2)
Pc
Connect Only
