SmartSiren Platinum Convergence Network
Federal Signal www.fedsig.com
Testing the Convergence Network Installation
50
Figure 33 LED indicators on lower label of siren amplifier/relay module
290A7568
ON:
LED glows when
the network has power.
RAD VOL:
Screw for
adjusting the factory-set
radio volume.
PA VOL:
Screw for adjusing the
factory-set public address volume.
(For special models with the
microphone connected to the siren
amplifier/relay module. This feature
is unavail for most models.)
5 A HORN:
5 A fuse for horn ring circuit.
SIREN 20 A:
20 A fuse for the siren.
The control head legends in the illustration are for a typical configuration.
The SSP3000B/SSP2000B kit includes additional legends. All buttons are
programmable. For instructions for programming the control head, see the
“SSP3000B Control Head Configuration Software Manual” (doc. no. 2562418).
Figure 34 LED programming indicators on the control head
Button LEDs:
All buttons on the
control head glow when the system
is on. Pressed buttons blink to
indicate that the function they
control is active.
SmartSiren® LEDs:
LEDs mimic these
active SignalMaster patterns: Left, Right,
Center-Out, or Warn patterns 1 to 4. They
also indicate when a programmed feature of
the key head is active (see “Setting Control
Head Options” on page 43.)
Slide Switch LEDs:
LEDs above the slide switch glow
when the system is on (1=green, 2=amber, 3=red). The
LED brightens above the position in which the slide
switch is placed.
