SmartSiren Platinum Convergence Network
Federal Signal www.fedsig.com
Setting Control Head Options
44
Selecting Active-High Activation of the Park Input Circuit
For instructions on connecting the control head to the Park Input circuit, see “Park
Input (Cable Assembly 1751542-01 or 1752542-NY)” on page 27.
The default setting is active-low. To select the active-high activation of the Park
Input feature:
1. While in Program Mode, press Button 9. LED 9 in Figure 25 turns on.
2. To continue, select another setting to change or press Button 13 to exit Program
Mode. Verify that the last amber LED turns on when you exit.
Dimming or Turning Off the Button LEDs
To dim or turn off the button LEDs:
1. While in Program Mode, press Button 8 up to four times to step though
decreasing levels of brightness. See Figure 25 on page 43. To turn off the
LEDs, press Button 8 a fifth time.
2. To continue, select another setting or press Button 13 to exit Program Mode.
Verify that the last amber LED turns on when you exit.
Configuring Keep-Alive Timeout
For instructions on connecting the ignition sense, see “Connecting Power to the
Control Head (with Ignition Timer)” on page 33. The default setting is to disable
the control head immediately with ignition. To maintain power to the SmartSiren
Platinum control head and other Convergence Network devices after ignition is
removed:
1. While in Program Mode, press Button 4. The first press enters the Keep Alive
Timeout menu, and Button 4 starts flashing. Press Button 4 to increase the
length of time the control head stays alive. The amber LEDs indicate the
timeout level. See Figure 26.
2. To return to the Program Menu, press any other button or wait five seconds. To
continue, select another setting or press Button 13 to exit Program Mode. Verify
that the last amber LED turns on when you exit.
