SmartSiren Platinum Convergence Network
Federal Signal www.fedsig.com
Safety Messages for Installers and Operators
10
stare directly into this lighting product at a close range or permanent damage
to your eyesight may occur.
• It is important that you fully understand how to safely operate this warning
system before use.
• Operate your vehicle and its light/sound system in accordance with your
department’s Standard Operating Procedures.
• If a selected function does not perform properly or if any of the lamps remain
illuminated when the control is off, disconnect the power connector from the
control unit and contact the nearest service center.
• At the start of your shift, you should ensure that the entire warning light system
and the siren system is securely attached and operating properly.
• The effectiveness of an interior mounted warning light depends on the clarity,
the tinting, and the angle of the glass it is being placed behind. Tinting, dirt,
defects, and steeply angled glass reduce the light output of the warning light.
This may reduce the effectiveness of the light as a warning signal. If your
vehicle has dirty, tinted, or steeply angled glass, use extra caution when driving
your vehicle or blocking the right of way with your vehicle.
• Suction cup mounting is for temporary applications only. The unit should be
removed from the window and stored securely when not in use. Temperature
changes and sunlight can cause suction cups to lose holding power.
Periodically check the unit to be sure the suction cups have a firm grip on
the mounting surface. An improperly secured light could fall off of the vehicle
causing injury and damage.
• The holding power of magnetic mounting systems is dependent upon surface
finish, surface flatness, and thickness of the steel mounting surface.
• Therefore, to promote proper magnetic mounting:
• The mounting surface and magnets must be kept clean, dry, and free of
foreign particles that prevent good surface contact.
• Ensure that the mounting surface is flat.
• A magnet mounting system should not be used on vehicles with vinyl
tops.
• To prevent the light assembly from sliding on mounting surface, avoid
quick acceleration and hard stops.
Failure to follow these precautions may result in property damage, serious injury, or
death.
RETAIN AND REFER TO THESE MESSAGES
