![background image](http://html1.mh-extra.com/html/federal-signal-corporation/smartsiren-platinum-ssp3000b/smartsiren-platinum-ssp3000b_installation-and-maintenance-instructions-manual_3813875012.webp)
SmartSiren Platinum Convergence Network
Federal Signal www.fedsig.com
An Overview of the SmartSiren Platinum
12
Programmable Input Circuits
Both models of the siren amplifier/relay modules have connections for four relay
input circuits. Relay inputs 1 and 2 are active-low inputs that activate a switch when
pulled to ground. Relay inputs 3 and 4 are active-high inputs that activate a switch
when pulled to 12 Vdc battery voltage. The inputs are most commonly used for
switches that send a signal to the siren amplifier/relay module when a condition in
the vehicle changes. Changes may include the opening of a trunk or door, a rise in
vehicle temperature, or the release of a gun lock.
The control head has connections for four active-low inputs that activate when
pulled to ground. Similar to the relay circuits, they can be configured to operate
with the Convergence system control head or with the configurable switches on
the steering wheel of the Ford Police Interceptor.
LED Indicators and Visual Diagnostics (Model SSP3000B Only)
LEDs visible just below the surface of the siren amplifier/relay module indicate
when power is supplied to the auxiliary outputs and if the module is transmitting
and receiving data. LEDs also indicate when a signal is received by the four input
circuits and if the light bar is functioning. Externally mounted mini-blade fuses for
the siren, horn-ring circuit, SignalMaster
™
, and auxiliary relays have LEDs that glow
when the fuse fails, making them easy to spot.
All buttons on the control head glow when the system is on. Pressed buttons turn
bright to indicate that the function they control is active. LEDs under the SmartSiren
logo mimic these active SignalMaster patterns: Left, Right, Center-Out, or Warn
patternspatterns 1 to 4. An LED glows over the position in which the slide switch is
placed.
Table 1 System Specifications
Input Voltage
11 Vdc to 16 Vdc
Polarity
Negative ground only
Operating Temperature Range
-40°C to +65°C (relays at full power)
-40°C to +80°C (relays at 60 percent power)
Standby Current
Less than 0.2 A
Dimensions:
Amplifier/relay module
Height x Weight x Length
4.22 x 7.94 x 6.81 inches (10.72 x 20.17 x 17.3 cm)
Net Weight
5.40 lb (2.45 kg)
Control head
Height
3.26 in (8.28 cm)
Width
1.62 in (4.11 cm)
Length
6.80 in (17.27 cm)
Net Weight
0.8 lb (0.36 kg)
Shipping Weight
10.0 lb (4.53 kg)