22
Installing the Mobile Camera System
Mobile Camera System
Federal Signal
www.fedsig.com
4.
Drill a 3/4-inch (19.0 mm) hole at the mark for the camera
output cable. Smooth and deburr the hole.
Mounting the Ball Camera
To mount the camera:
1.
Align the bottom half of the camera mounting bracket with
the drilled mounting holes on the vehicle while inserting the
insulating pad between the vehicle surface and the camera
mounting bracket.
2.
To affix the bottom half of the camera mounting bracket
to the vehicle, choose the appropriate screws for the
mounting holes you drilled.
• If you are using the self-tapping screws, guide
each screw through the bottom half of the camera
mounting bracket and then into the drilled holes.
Fasten the screws tightly to the vehicle body.
• If you are using the machine screws, guide each
screw through the camera mounting bracket and then
into the drilled holes. Install the matching lock and flat
washers followed by the nuts on the opposite side of
the vehicle surface. Fasten the mounting hardware
tightly to the vehicle body.
3.
Install the camera while adjusting the viewing angle in
the mounting bracket using the included Allen
®
wrench.
To verify the image orientation, connect the camera to
the monitor with a camera extension cable. It may be
necessary to rotate the camera in the mounting bracket to
obtain the correct orientation. Once you obtain the image
you want, tighten the screws on the mounting bracket to
fix the camera position.
4.
Wrap the cable connection in the supplied black
waterproofing tape.