13
Installing the Mobile Camera System
Installation and Operation Manual
Federal Signal
www.fedsig.com
3.
Drill holes at the drill position marks that are correctly
sized for the screws you are using:
• If you are using the self-tapping screws, drill two to
four 9/64-inch (3.5 mm) holes.
• If you are using the machine screws, drill two to four
13/64-inch (5.2 mm) clearance holes.
4.
Drill a 3/4-inch (19.0 mm) hole at the mark for the camera
output cable. Smooth and deburr the hole.
Mounting the Rear-View Camera
To mount the camera:
1.
Install the insulating pad on the bottom of the camera
mounting bracket. If you are using the center hole in
the bracket for the camera output cable, route the cable
through the hole.
2.
Align the mounting bracket with the drilled mounting
holes, guide the camera output cable into the 3/4-inch
(19.0 mm) hole, and secure the rubber grommet in the
hole.
3.
To fasten the mounting bracket to the vehicle, choose the
appropriate screws for the mounting holes you drilled:
• If you are using the self-tapping screws, guide each
screw through a plastic insulator and then through
one of the two channels in the mounting bracket and
into the drilled holes. Fasten the screws tightly to the
vehicle body.
• If you are using the machine screws, guide each screw
through a plastic insulator and then through one of the
two channels in the mounting bracket into the drilled
holes. On the opposite side of the vehicle chassis at the
mounting location, install the flat washer followed by
the lock washer and nut. Fasten the mounting hardware
tightly to the vehicle body.