16
Installing the Mobile Camera System
Mobile Camera System
Federal Signal
www.fedsig.com
To verify the orientation of the camera in its housing
before the installation, connect the camera to the monitor
and turn on the system.
You can adjust the camera assembly inside the housing
for either the left or right side of the vehicle. If the image
on the monitor appears upside down on the preferred
installation side of the vehicle, use the Allen
®
wrench to
remove and flip the camera assembly 180 degrees. Then
install it to switch the camera from a left-side-view camera
to a right-side-view camera or vice-versa.
Marking and Drilling the Mounting Holes for the Side-View
Camera
AIRBAG DEPLOYMENT: Do not install equipment or route
wiring in the deployment path of an airbag. Failure to observe
this warning will reduce the effectiveness of the airbag or
potentially dislodge the equipment, causing serious injury.
SEAT REMOVAL PRECAUTION: If a vehicle seat is temporarily
removed, verify with the vehicle manufacturer if the seat
needs to be recalibrated for proper airbag deployment. Failure
to heed this warning could result in death or serious injury.
LOCATING OPERATORS CONTROLS: Locate the camera(s)
so the VEHICLE and SYSTEM can be operated safely under all
driving conditions. Failure to heed this caution could result in
driver distraction or driver error while operating the vehicle.
To mark and drill the mounting holes:
1.
Use the mounting base as a guide to mark the locations
of four mounting holes on the vehicle chassis and the
3/4-inch (19.0 mm) hole for the camera output cable. Once
you drill this hole, you can route the camera output cable
through it to: