17
Installing the Mobile Camera System
Installation and Operation Manual
Federal Signal
www.fedsig.com
• a camera extension cable that can be:
◦
one CAMCABLE-SHORT/-5/-10/-15/-20/-40
that is connected to:
◦
either the CAM1 or CAM2 input on the input/
power/trigger wiring harness (CAMADP-INT-2) of
the CAMLCD-AHD-56 monitor or
◦
one of the four camera inputs on the input/power/
trigger wiring harness (CAMADP-INT-4) of the
CAMLCD-AHD-70
DRILLING PRECAUTIONS: When drilling holes, check the area
into which you are drilling to ensure that you do not damage
vehicle components while drilling. All drilled holes should be
deburred, and all sharp edges should be smoothed. All wire
routings going through drilled holes should be protected by a
grommet or convolute/split loom tubing.
2.
Whether you are using self-tapping or machine screws,
drill 0.116-inch (3.0 mm) holes (a #32 drill bit can be used)
at the marked positions for the four mounting holes.
3.
Drill a 3/4-inch (19.0 mm) hole at the mark for the camera
output cable. Smooth and deburr the hole.
Mounting the Side-View Camera
To mount the camera:
1.
Align the mounting base with the drilled mounting holes
on the vehicle. Guide the camera output cable into the
3/4-inch (19.0 mm) hole and secure the rubber grommet
on the cable in this hole.
2.
To affix the camera to the vehicle, choose the appropriate
screws for the holes you drilled above:
• If you are using the self-tapping screws, guide each
screw through the camera base and then into the