18
8 TIPS FOR CORRECTING MINOR DEFECTS
Before you begin maintenance and repair work, you must disconnect the unit from the mains.
Repairs should only be performed by the uwe company or by authorised persons. Safety devices
must not be removed or disabled. After each repair, there must be made an examination of the unit,
which has to be reported.
Warning
Warning
Warning
Warning
•
BreakSafe
All XTT filter disks are secured by micro-switches, this means, that if the filter disks are o.k., the electrical cir
cuit is closed. If one filter disk breaks, then the electrical circuit will be interrupted and the unit can not be
operated any more. Then the broken filter disk must be exchanged. On the assembly plate control unit (20)
there is a platine with relais and four light-emitting diodes. One LED each belongs to the tanning arm and to
the lounger, respectively. The broken filter disk is located there, where the LED does not shine.
•
The high pressure burners don’t switch on
Exchange the high pressure burner. If this doesn’t help, exchange the ignition unit. The ignition units of the high
pressure burners of the tanning arms are situated below the covering hood (66, picture 3). Dismantle for that
purpose the waved covering hood (83) and un-screw the covering hood (66). The ignition units of the high-
pressure burners of the lounger are located in the light-casing (6). These can be accessible, after disassem-
bling the disk holder (75, picture 7) and the reflector (87). If this does not help, there is an electrical defect in
the unit.
Checking-up by uwe or by another firm named by uwe.
•
The illumination light does not shine (exchange of starter, picture 4)
Take up a little bit the acrylic sheet lounger (1) at the foot and pull forward the small covering hood (57)
thereunder. The illumination bulb and the starter are now open accessible. Check up, if the bulb is inserted
correctly. Then check up, if the starter is located correctly. Take the starter out of the light by turning to the left
side, and then tighten it up again by turning to the right side. If the light does not shine, insert a new starter. If
this does not help, the bulb must be checked up. Insert a new bulb. If the light shines then, the old bulb was
defect and the error has been corrected. If it still does not shine, there is an electrical defect in the unit.
Check should be performed by uwe or by an authorised agent appointed by uwe.
•
A tanning arm or the tanning lounger gets too hot
Check whether the air intake filters (Filter Mats) are clogged. In the case of direct air extraction ensure that
the warmed cooling air is fed to open air without any significant obstacle. There must be no blockage in the
hose or the ventilation duct since this will cause the unit to overheat.
Check should be performed by uwe or by an authorised agent appointed by uwe.
8
BREAKSAFE LED for base
BREAKSAFE LED forarm left
BREAKSAFE LED for arm right
plug connection of the
BREAKSAFE CONTROL
X 5a
x 6a
x 7a
x 8a/9a
BREAKSAFE LED
for arm top
arm top
arm right
arm left
base
1
2
4
5
6
7
8
3
