13
Function
Warning
Cover of the Lights
The sources of UV-radiation in the arms are covered each by one 3-4,5 mm thick filter with the denomination Type
322 XTT (PKZ 02935) and by one disk out of 3 mm thick acrylic glass. The sources of UV-radiation in the lounger are
covered each by one 3-4,5 mm thick filters with the denomination Type 324 XTT (PKZ 02936) and with one disk out of
6 mm thick acrylic glass. Between the lights and the light-casing there is a reflector made out of high-gloss rolled,
electrolytic polished and anodized aluminium.
In case of any modification of the disks, the burners, of other spare parts, the TUV-certification (technical control
board) shall lapse.
Always ensure to get only genuine spare parts, either from uwe or from any other authorized specialized store.
4.2 Before Setting into Operation
Before installation and setting into operation, the Safety Instructions and Operating Instructions must be carefully
read and observed.
4.3 Setting the Unit into Operation for the First Time
Before the unit is set into operation, the local safety regulations and the Safety Instructions must always be obser-
ved. When the unit is completely installed, electrically connected and connected to the coin operation system or
central control system, it can be set into operation.
Instructions to the operator:
Do not put defective sunbathing equipment into use.
Observe the maximum permissible room temperature (max. 95
°
F), otherwise there’s the
danger that the area to lie on gets too hot.
Observe hygiene requirements.
Provide protective glasses and ensure that they are used.
Highlight the need to adjust the length of the sunbathing period depending on skin type.
Keep user instructions at hand.
Put up the safety instructions and the time chart in the sunbathing room in a clearly visible position.
There is a sticker on the acrylic sheet with important information in 4 languages.
Please note the information and then remove the sticker.
5 CLEANING - IMPORTANT INFORMATION FOR THE OPERATOR
Ensure extremely strict hygiene on the tanning unit and in its vicinity. Dust deposits reduce the
Tanning effect. Do not spray cleaning materials into the eyes. Do not spray them into naked flames.
Do not drink them. They must not be accessible to children. Do not pour liquids over the unit so as to
avoid moisture penetrating under the covers and onto the electronics. Use cleaners in accordance
with the instructions. Observe the manufacturer’s soaking times.
•
Body
Clean the painted external surfaces of the unit with a slightly damp cloth; some detergent can be added to
the water. Do not use abrasive materials. Stubborn dirt can be removed with a soft cloth and a biodegrada-
ble cleaning material (e.g. vinegar-based cleanser).
•
Acrylic sheet
Use only the genuine uwe PICCOBELLO cleanser or the „Paletti Hydrovlies“ tissues. If cleaning materials other
than these are used, we cannot accept any warranty liability. When using the uwe cleanser PICCOBELLO, spray
it onto the acrylic sheet and let it react for 60 seconds. Always dry it off with a clean cloth. Occasionally, also
clean the side of the acrylic sheet facing the lamps. To do this, take the acrylic sheet off.
•
Reflector
When exchanging the burner, clean the reflectors with a cloth soaked with alcohol.
