8
3
Function
44
40
92
41
43
66
81 80 78
9
3 10 4
83
86 85
66
107
108
107
84
104 84 94
46 45
48
64
34
•
Assembly of the upper tanning arm (41, picture 3)
Take the upper tanning arm (5 sunbathing units) and hold it in front of the respective place of installation at the
tripod. First pull the cable X5 (42, picture 2) with the 18-poled plug-in connection and the 4-poled cable X5a
(105) through the gap relief (25 x 25 mm) into the tripod. Then introduce the pins (64) of the arm into the gaps
of the tripod. Thereby push the acrylic sheets (43) over the support (44) of the covering hood (40). After this,
secure- coming from the tripod the four pins (64) with disks (46) having an external diameter of 25mm and with
hexagonal nuts (45).
You really must tighten up the nuts (45).
Pull the both cable with plug X5, X5a (42, picture 2) down onto the bottom of the tripod, and through the gap
of the tripod into the footrack.
Put the plug X5 (42) together with the corresponding socket connector X5 (47) of the insertion arm upside.
Put the plug X5a together with the corresponding socket connector X5a of the BreakSafe Control (105) on
the Control Board.
Put the pin casing X1 (18) of the assembly plate arm top (21) together with the respective 18-poled socket
connector X1 (106) of the assembly plate control unit.