10
4
Warning
Warning
•
Assembly of the lounger (picture 4).
Place the pipeframe (2) over the footrack. Take care, that the front foot is being fixed by the support (73).
Attention! The feet of the pipeframe are adjustable for height. The knurling screws (103) have been
unscrewed up to 25mm ex works. Please check! If not, unscrew the knurling screws up to 25 mm. You
must adjust the pipeframe to the conditions of your ground.
1.
Place the pipeframe over the footrack.
The footrack must stand up straight.
2.
Level out the unevenness of your ground with the knurling screws. To achieve this, rather unscrew than tighten
up the knurling screws.
Fix the pipeframe by tightening up the screws (M8 x 20) through the long holes of the edges (93) into the nuts
welded into the tripod. Then arrange the three covering hoods (56, 57, 58) around the pipeframe. The two
covering hoods (56 and 58) arranged on the sides of the pipeframe will be fixed onto the tripod by a strip
fastener and screwed together at the front side with their fastening tabs (4,2 x 9,5). On these fastening tabs the
small covering hood (57) will then be fixed, again by strip fasteners, starting from the front. Check, if the
vertical plate (101) is assembled. Then, together with someone else, take up the acrylic sheet (1) and place it
on to the pipeframe. The acrylic sheet will be supported by the vertical plate (101).
Attention!
The border circulating the acrylic sheet slips over the edges of the 3 covering hoods.
The acrylic sheet shall not rest on top of the covering hoods! The space between acrylic
sheet and the covering hoods should be approx. 5 mm.
If this space is not ensured, readjust the knurling screws.
61
60
59
55
1
93
58
101
103
2
82
57
73
56
