September 2015
www.farmscanag.com
AM-JACKAL-3
27
Slippage Meter (Wizard)
SLIPPAGE METER (WIZARD)
The Jackal can provide the operator with the ability to compare two inputs and provide the
result as a percentage. This is applicable when speed over ground is not necessarily equivalent
to rotational speed of the wheel/s. This will enable you to set up a comparison between wheel
speed and actual speed (using GPS)
Sensors Required:
x
Wheel sensor input (wheel or shaft pickup)
x
GPS
Available Connections (
This setup section assumes that physical wiring for the required sensors have been
completed. If not please refer to
SETUP
From the front screen press
SETUP
Highlight
WIZARD
& press
SELECT
Highlight
SLIPPAGE METER
press
NEXT
Highlight the
INPUT
number
X: the WHEEL sensor wire is
connected into on the rear
of the Jackal & press
NEXT
Press the
EDIT
button to
change the baud rate, when
the correct baud rate is
selected the corresponding
NMEA message will be
acknowledged with a Y.
Press
NEXT
As indicated, drive above
3km/hr
Wheel input will then
increment up (displayed in
Hz) & GPS speed will start to
show.
As the system
self-calibrates the slip % will
get closer to 0%.
When the slip has settled
close to 0% press
NEXT
You have the option to set
Alarm Min/Max points if
required. Using the NAV
buttons select & EDIT as
required. Press NEXT
There is no need to EDIT the
name. It will default to GPS
Press NEXT
Finally acknowlege that you
wish to also display Speed
(km/hr) on the front screen
with the area covered.
Press
YES
The Wizard is now complete.
Press NEXT.
Press EXIT to return to the
front screen
THIS ENDS THE SETUP WIZARD FOR WHEEL SLIPPAGE
VERSUS
Summary of Contents for Jackal v2
Page 1: ......
