September 2015
www.farmscanag.com
AM-JACKAL-3
7
Connections
INSTALLING SENSORS
The following examples will help to determine appropriate sensor input connections into the Jackal.
TWO WIRE “REED” SENS
OR KITS
1007P, 2009, 2076
These kits will all include a “reed” type sensor. The reed type
sensor is a 2 wire sensor (normally black end) and only uses a
ground/earth wire and a signal wire.
The diagram to the right shows which terminals to connect
your sensors to. If the ground/earth
(A1)
terminal already has
a wire from another sensor applied to it then you will need to
piggy back onto this wire. If the signal port
(B2-B6
) has wires
from another sensor applied to it then move to one of the
ports shown that is free.
Use the wizard to setup the port and calibrate a sensor once installed.
TWO WIRE “COIL”
OR FLOW SENSOR KITS
2034, 2077, AA-230S/RCS
These kits will all include a “coil” type sensor. The coil type
sensor is a 2 wire sensor (normally yellow end) and only uses a
ground/earth wire and a signal wire. A 2 wire sine wave flow
sensor input can also be used, found in
the 2”
AA-231 kit.
The diagram to the right shows which terminals to connect
your sensors to. If the ground/earth
(A1)
terminal already has
a wire from another sensor applied to it then you will need to
piggy back onto this wire.
NB : There is only ONE (1) coil input on the Jackal
Use the wizard to setup the port and calibrate a sensor once installed.
TWO &
THREE WIRE “REED/PROX/FLOW” SENSOR KITS
AA-2010P, AA-123P, AA-125, AA-242, AA-230X, AA-232X, AA-231
These kits will all include a “reed” type “proximity” sensor or
“square wave” flow sensor input. The proximity or flow sensor
(Rapid Check) is a 3 wire sensor and uses a ground/earth wire, a
signal wire and a 12v power wire. All reed style are two wire.
The diagram to the right shows which terminals to connect your
sensors to. If the ground/earth
(A1)
or regulated 12v power
(OUT2,
B9)
terminal already has a wire from another sensor applied to it
then you will need to piggy back onto this wire. If the signal ports
(B2-B6)
has wires from another sensor applied to it then move to
one of the ports shown that is free.
Use the wizard to setup the port and calibrate a sensor once installed.
Summary of Contents for Jackal v2
Page 1: ......
