September 2015
www.farmscanag.com
AM-JACKAL-3
43
Other Settings (Manual Setup)
OTHER SETTINGS (MANUAL SETUP)
Other settings is used to setup Implement width for displaying Ha,Ac, Enable/Disable remote run/hold function,
audible alarm notifications & language control.
FRONT SCREEN > SETUP > OTHER SETTINGS
If you wish to display Ha/Ac on the front screen you need to have an implement width set.
By default the Jackal displays 8m.
You can adjust the implement with and choose your UOM (m, ft, yd, in, km, mi).
If the UOM & implement widths remain untouched the Jackal will not display the information unless specified in the
FRONT
SCREEN
setup.
The
EXTERNAL RUN/HOLD
function can be used to enable/disable all accumulating values and alarms set in the Jackal
without pressing the
RUN/HOLD
on the Jackal itself.
NOTE
–
When the
EXTERNAL RUN/HOLD
is active on ANY input the function of the RUN /HOLD button on the front screen is
disabled.
The trigger wire can be applied to any of the 13 available inputs on the Jackal. To enable maximum flexibility for this function
NORMALLY ON
or
NORMALLY OFF
mode can be selected for this function.
When a circuit exists between the selected input and ground
(GND), selecting
NORMALLY ON
will result in the Jackal
going into HOLD mode
Selecting
NORMALLY OFF
will result in the reverse i.e. the
Jackal will be in
RUN
mode until the circuit is broken after
which it will go into
HOLD
mode.
After you select the desired hold method select the
INPUT#
port that is being used to detect Run/hold
DISABLED: External Run/Hold is not used. Use the Run/Hold button only.
Summary of Contents for Jackal v2
Page 1: ......
