September 2015
www.farmscanag.com
AM-JACKAL-3
18
Area & Speed Meter Setup (Wizard)
CALIBRATION (MANUAL SET)
1.
Ensure that the sensor & pickup are end-end before continuing
2.
Mark bottom centre of tyre on which the sensor is fitted and mark ground in corresponding position
3.
Drive one full rotation of the wheel, returning mark point on tyre to bottom centre
4.
Measure between the two points.
o
This is your Manual Ratio (Example 1.24m)
Highlight 1.000000
(Under Manual Ratio)
Press EDIT
Using the NAV buttons enter
your measured distance. i.e.
1.240000
Press EXIT when done.
MANUAL RATIO will now be
updated to reflect the
calibration factor.
Press NEXT
For the Jackal to correctly
read hectares/acres an
implement width needs to
be entered. Press
EDIT
(You can RIGHT NAV button
once & select
EDIT
to
change M to FT,YD,IN)
Using the NAV buttons enter
your implement width in (m).
e.g. 18m
Press EXIT when done
You can choose to enable the
remote run/hold input
(Further info
) or
edit the AlarmBeep in
seconds.
Press
NEXT
Using the NAV buttons select
how you would like the area
to be displayed on the front
screen.
Press NEXT
You have the option to set
Alarm Min/Max points if
required. Using the NAV
buttons select & EDIT as
required. Press NEXT
Name the input if you desire,
Press EDIT. e.g. WHEEL, press
EXIT
Press NEXT
Finally acknowlege that you
wish to also display Speed
(km/hr) on the front screen
with the area covered.
Press
YES
The Wizard is now complete.
Press NEXT
You will be returned to the
Setup Screen.
Press EXIT
THIS ENDS THE MANUAL RATIO SET WIZARD SETUP FOR SPEED/AREA METER
Summary of Contents for Jackal v2
Page 1: ......
