Farm King VT3290, Operator And Parts Manual, Page: 76 / 232

Assembly - VT3000 Series
74
Figure 119
Position outside gang section, at correct distance
(Item 1)
[Figure 119] from the end of the gang
beam.
NOTE: Reference diagrams on page 62 for
correct distance (Item 1) [Figure 119].
IMPORTANT
Always tighten inside hanger bearing bolts first,
while maintaining designated blade spacing.
Tighten all bearing hanger bolts to 430 ft.-lb. (583
N•m) torque.
Verify that all bearing hangers are positioned
square under gang beam before tightening the
bolts.
Tighten inside hanger bearing bolts, then tighten
remaining hanger bearing bolts on the front inside
gang section.
Install remaining gang sections. (See “Installing
The Gang Sections” on page 70.)
1
CENTER BLADE
Figure 120
Locate and install the center gang beam (Item 1)
using two 3/4” x 6-7/8” u-bolts (Item 2)
[Figure
120] , 3/4” lock washers and 3/4” nuts.
Figure 121
Align the center gang beam (Item 1) with the
mounting flanges (Item 2) on the main frame.
Install one 3/4” x 6-7/8” u-bolt (Item 3)
[Figure
121] up over the center gang beam and into the
main frame mounting flange (both sides).
Install 3/4” lock washers and 3/4” nuts onto the
u-bolt (both sides). Tighten u-bolts to secure the
center gang beam to the main frame.
1
2
2
3
2
1