Farm King VT3290, Operator And Parts Manual, Page: 109 / 232

Operation - VT3000 Series
107
Tilling Angle Adjustment
Connect the VT3000 to the tractor.
Unfold wings.
Position the gangs to the desired tilling angle as
shown
[Figure 165] .
Figure 165
Remove bolt (Item 1) [Figure 165] and nut. Move
gang to the desired work angle.
Install bolt and secure the gang section in desired
work angle.
Repeat for remaining gang sections.
NOTE: With the capability of changing the degree
of angle (0°, 4°, 8°, 12° & 16°), for Spring work
set the gangs at a lesser degree to open up
the soil and in the Fall set the gangs at a
higher degree so the blades’ cutting action
will be more aggressive with the soil and
residue.
16°
12°
8°
4°
0°
1
Left to Right
Move to the operator’s position.
Park the tractor / equipment on a flat level surface.
Unfold wings so blades are 2” to 3” (51 mm to 76
mm) off the ground.
Stop the tractor and leave the operator’s position.
Figure 164
Level the left and right wings by adjusting the
wing lift cylinder mounts on each wing.
Loosen the nuts (Item 1) [Figure 164] of each
mounting bolt and move the cylinder forward or
rearward to adjust.
Tighten nuts (Item 1) [Figure 164] when left and
right wing blades are an equal distance off the
ground.
NOTE: Lowering the machine may make adjusting
easier.
NOTE: Level machine after changing tractor
drawbar height.
1
1