Farm King VT3290, Operator And Parts Manual, Page: 56 / 232

Assembly - VT3000 Series
54
Figure 91
Fully extend the front and rear RH & LH wing
cylinders.
Turn tractor engine off and exit the tractor.
Align the clevis (Item 1) with the mounting bracket
(Item 2)
[Figure 91] on the RH & LH wings.
Figure 92
Install one 1-9/32” ID x 2” OD x 1/4” washer onto
the end of the cylinder pin.
Push the pin through the first bracket of the
cylinder mount, install one 1-9/32” ID x 2” OD x
1/4” washer, then push pin through the cylinder
clevis.
RH WING CYLINDER
2
1
2
1
Pressure And Return Hose Fittings
Figure 90
Install and tighten the male quick coupler fitting
(Item 1)
[Figure 90] on each set of hydraulic hoses:
wing fold hoses (Blue tie straps) and raise / lower
hoses (Green tie straps).
Connect the hydraulic hoses to the tractor’s
auxiliary hydraulics.
Enter the tractor, start the engine and move the
tractor in front of the VT3000 hitch.
Engage parking brake and exit the tractor.
Open the two shut-off valves.
Enter the tractor and engage tractor auxiliary
hydraulics. Using the tractor’s auxiliary controls,
cycle the hydraulic cylinders on the VT3000 to
remove all air from the system.
IMPORTANT
When cycling wing lift cylinders, be sure the ends
of the cylinder rods do not contact any part of the
frame. Cylinder rods will bend if they contact a
frame component.
1