Farm King VT3290, Operator And Parts Manual, Page: 59 / 232

Assembly - VT3000 Series
57
WING STOP LINKS
Figure 96
Locate the two wing stop links (Item 1) [Figure 96] .
Align one wing stop link with the mounting
brackets (Item 2)
[Figure 96] on the main frame
(both sides).
Figure 97
Locate one 1-1/4” x 8-5/8” pin, four 1-9/32 ID x 2”
x 1/4” washers, two lynch pins, one caster pin and
two 5/16” x 2” cotter pins.
Install the 1-1/4” x 8-5/8” pin (Item 1) through
the wing stop link and mounting brackets (inside
brackets) on the main frame. Place one 1-9/32 ID x
2” x 1/4” washer (Item 2) and one lynch pin (Item
3)
[Figure 97] on each end of the 1-1/4” x 8-5/8”
pin.
Install caster pin (Item 4) [Figure 97] through wing
stop link and outside brackets on the main frame.
Install one 1-9/32 ID x 2” x 1/4” washer (Item 5)
and one 5/16” x 2” cotter pin (Item 6)
[Figure 97]
on each end of the 1-1/4” x 8-5/8” pin.
3
2
1
6
4
5
2
1
Purging Hydraulic Cylinder
Disconect and fully retract the cylinder rod.
Cylinder pin to pin length should be approximately
42.38” when fully retracted.
Support the cylinder so that the rod can extend
and retract freely.
Fill the cylinder rod side with hydraulic oil. Connect
the hoses to tractor or hydraulic power unit.
Cycle the cylinder from maximum retract to
maximum extend multiple times to purge air.
Continue until the cylinder moves smoothly in
both directions. The cylinder is equiped with a
flow orifice and should move slowly.
Extend the cylinder and align the rod and hitch
mount. Reattach the cylinder rod to the hitch
mount using cylinder pin and cotter pin.
WARNING
HIGH PRESSURE FLUID HAZARD
Leaking fluids under pressure can enter the skin
and cause serious injury or death. Immediate
medical attention is required. Wear goggles. Use
cardboard to check for leaks.