Falcon E3840, Installation, Servicing And User Instructions Manual, Page: 25 / 37

21
13.
Allow pan to fill with oil.
14.
Once oil has been returned to pan, switch oil pump off by means of filter pump switch.
15.
Replace element guard.
16.
Top up oil to correct level.
Warning
Ensure all shortening has been pumped from receptacle before
topping up pan.
Please Note
If the E3840X & E3840FX pan has not been refilled until at least the
low oil level indication (Flashing hazard triangle) clears, then the
elements will not switch on.
8.0 CLEANING & MAINTENANCE
BEFORE ANY CLEANING IS UNDERTAKEN, ISOLATE APPLIANCE FROM MAINS POWER SUPPLY
AT ISOLATOR SWITCH.
SUITABLE PROTECTIVE CLOTHING MUST BE WORN WHEN CLEANING THIS APPLIANCE.
NEVER PUMP WATER THROUGH THE FILTRATION PUMP AT ANY TIME! WATER AND HOT OIL
ARE AN EXPLOSIVE MIXTURE.
OIL MUST BE ALLOWED TO COOL TO A SAFE TEMPERATURE BEFORE DRAINING. DO NOT
OVERFILL OIL BUCKET. ALL SPILLS ONTO THE PRODUCT AND ON THE FLOOR SHOULD BE
CLEANED UP IMMEDIATELY.
THE APPLIANCE MUST NOT BE CLEANED WITH A JET OF WATER OR BE STEAM CLEANED. DO
NOT USE ACID OR HALOGEN-BASED (E.G. CHLORINE) DESCALING LIQUIDS, FLAMMABLE
LIQUIDS, CLEANING AIDS OR CLEANING POWDERS.
FAILURE TO CLEAN AND CHECK THE SAFETY AND OPERATIONAL THERMOSTATS CAN IMPACT
THE PERFORMANCE OF THE APPLIANCE AND INCREASE THE RISK OF AN APPLIANCE FIRE.
FAILURE DUE TO LACK OF PROPER CLEANING IS NOT COVERED BY WARRANTY.
Note: All surfaces are easier to clean if spillage is removed before it becomes burnt on, cleaned daily.
Stainless Steel Surfaces
It should be noted that certain scouring pads including nylon types, could easily mark stainless steel.
Care should be exercised during cleaning process.
When rubbing stainless steel with a cloth, always rub along in grain direction.
The following procedure should be undertaken, AT LEAST DAILY.