12
3.1
INTEGRAL COMPONENTS
The following parts must be checked and serviced regularly:
a)
Oil ingress to electrical components.
b)
Visual inspection of components and fryer pan.
c)
Temperature limit thermostat calibration.
3.2
ACCESS PROCEDURES
Before removal of any fryer components:
a)
Ensure appliance electrical supply has been shut off and cannot be accidentally turned back
on.
b)
Allow oil to cool before any operation that requires pan to be drained.
c)
Only use parts specified by the manufacturer.
d)
All components replaced MUST be fully checked after fitting to ensure safe operation.
e)
A full pre-commissioning check as detailed in Section 2.4 should be carried out.
3.3
ELEMENTS
a)
Remove fixings from element box lid and release element cables.
b)
Tilt element box and rest in upright position.
c)
Remove four fixings from element mounting plate.
d)
Remove element and seal.
e)
Replace in reverse order.
3.4
TEMPERATURE CONTROLLERS
a)
Remove control panel by undoing fixings at top and bottom.
b)
Disconnect electrics and remove fixings to enable controller to be removed.
c)
Carefully replace in reverse order.
3.5
MAINS ON and HEAT DEMAND NEONS
a)
Remove control panel by undoing fixings at top and bottom of control p a ne l .
b)
Remove electrical connections from neon. Undo neon retention nut.
c)
Carefully replace in reverse order.
3.6
DRAIN VALVE
a)
Ensure fry pot is empty. Refer to Section 8.
b)
Remove nut from handle and lift handle off.
c)
Remove front panel fasteners.
d)
Disconnect wiring, noting all connections.
e)
Remove front panel to access drain valve.
f)
Undo drain pipe. Use appropriate size of spanner to remove drain valve.
g)
Replace in reverse order and check for oil leaks.
3.7
FILTRATION PUMP
a)
Remove rear access panel. Disconnect pipe at filtration pump.
b)
Disconnect electrical coupling plug and start capacitor connections.
c)
Remove nuts from pump mounting bolts (accessed through fryer door at rear of oil
bucket compartment) and lift pump clear.
d)
Disconnect pump from bracket. Replace in reverse order.
Summary of Contents for E3840
