BIO Pellet Stoves
24
•
IF THERE IS A PROBLEM
Problem
Cause
Solution
The control panel doesn’t
start
•
The stove hasn’t got electrical input
•
Card protection fuse is burned
•
Control panel is faulty
•
Flat cable is faulty
•
Electronic card is faulty
•
Verify if the plug is connected.
•
Replace the fuse. Call a specialised
technician.
•
Replace the control panel. Call a
specialised technician.
•
Replace the flat cable. Call a
specialised technician.
•
Replace the electronic card. Call a
specialised technician.
The fire goes out and the
stove stops
•
The tank is empty (less than 1/3 full)
•
Cochlea is blocked by a strange object
(ex. Nails)
•
Pellets aren’t of good quality
•
The phase 1 parameter set in the
electronic card is too low
•
Verify if there is an alarm activated on
display (ex. Al 8 Failure Depress, Al 7
Safety Thermal…)
•
Fill the tank.
•
Unplug the plug, move the inside
hand protection of the tank, empty the
tank, clean the cochlea e start again.
•
Try different types of pellets.
•
The pellets supply must be regulated
by a specialised technician.
•
Call a specialised technician to check
the stove and detect the problem.
The fire has a weak and
orange flame, pellets
don’t burn correctly and
the glass gets black
•
The air for combustion isn’t enough
•
The waste pipe is blocked
•
The stove is obstructed
•
Fumes extractor is damaged
•
Check the following: possible
obstructions of the air inlet on the
back of the stove: brazier grid holes
obstructed and/or brazier box with too
much hash: exchanger pipes too
dirty; clean the extractor blades and
its scroll (see Maintenance).
•
Exhaust chimney is partially or totally
obstructed (call an expert stove fitter
to check the chimney from the stove
outlet to the chimney pot). Have it
cleaned immediately.
•
Clean the stove inside (see
Maintenance).
•
Pellets can burn thanks to the
chimney flue depression without the
aspirator. Have it replaced
immediately as it can be bad for your
health. Call a specialised technician.
The exchanger fan keeps
working when the stove is
cold
•
Temperature fumes feeler is faulty
•
Electronic card is faulty
•
Replace the fumes feeler. Call a
specialised technician.
•
Replace the card. Call a specialised
technician.
Hash around the stove
•
Faulty or damaged doors strips
•
Fumes pipe tubes are not airtight
•
Replace the strips cod.
•
Seal immediately the pipe fitting (with
high temperature silicone) and/or
replace the pipes with new ones.
Fumes pipes that aren’t airtight can
be dangerous for your health. Call an
expert stove fitter.
When working normally
the stove display shows
“
Clean-brazier
”
•
Cleaning grate
•
The stove goes to minimum and
extraction ventilation to maximum: no
problem.
The stove switches off.
Alarm displayed “Al 1 alar
al 1 Blac-out”
•
Plug accidentally unplugged
•
Temporary power failure
•
Faulty electronic card
•
Verify the plug is plugged in.
•
Verify the power failure and start the
stove again.
•
Replace the card. Call a specialised
technician.
Summary of Contents for BIO80
Page 33: ...BIO Pellet Stoves 31...
