CNC8070
R
EF
. 0402
E
RROR
SOLUTIONS
Page 115 of 128
Errors 8000-8999
8254
'Too many axes in G20'
DETECTION
During editing.
CAUSE
Some of the parameters programmed for G20 are not allowed.
SOLUTION
Check the G20 programming syntax.
8256
'Nonexistent interpolator cycle instruction'
DETECTION
During editing and execution in MDI.
CAUSE
The programmed instruction does not exist.
SOLUTION
Refer to the programming manual.
8257
'There can be nothing after the name of the program or subroutine'
DETECTION
During editing.
CAUSE
The possible causes are:
1. In the block defining the name of the main program or subroutine, other characters
have also been written.
2. The name of the main program or subroutine has a blank space.
SOLUTION
The definition of the main program or subroutine can only be accompanied by a
comment. The forbidden characters are:
1. Main program: \ / : * ? " < > | and blank space.
2. Local subroutine: / ? " < > | ) and blank space.
8258
'Expression expected after #TIME'
DETECTION
During editing and execution in MDI.
CAUSE
The #TIME instruction has been programmed incorrectly.
SOLUTION
The dwell may be programmed in two ways with the instruction #TIME:
• #TIME [<expression>]
• #TIME [<expression>]
The parameter <expression> may be a whole number (integer), an arithmetic
parameter or a control variable.
8265
'Unknown or incomplete word'
DETECTION
During editing.
CAUSE
The possible causes are:
1. The programmed function, instruction or expression is not valid.
2. M function has been programmed wrong for a particular spindle.
3. #TOOL AX instruction programmed wrong.
SOLUTION
Refer to the programming manual to check the syntax of the instruction, function or
expression to be programmed.
8267
'Cycle variable without writing permission'
DETECTION
During editing.
CAUSE
An attempt has been made to write a cycle variable that does not have a writing
permission.
SOLUTION
The variable can only be read.
8275
'Too many M functions in the same block'
DETECTION
During editing.
CAUSE
Too many M functions in the same block.
SOLUTION
The maximum number of M functions allowed in the same block is 7.
8276
'Too many H functions in the same block'
DETECTION
During editing.
CAUSE
Too many H functions in the same block.
SOLUTION
The maximum number of H functions allowed in the same block is 7.
Summary of Contents for CNC8 070
