CNC8070
R
EF
. 0402
E
RROR
SOLUTIONS
Page 55 of 128
Errors 1000-1999
1503
'The variable requires programming an axis'
DETECTION
During execution.
CAUSE
An axis variable has been programmed, but no axis has been indicated for which to
read or write a variable.
SOLUTION
Refer to the programming manual for control variables.
1504
'The variable does not allow programming an array index'
DETECTION
During execution.
CAUSE
An array index has been programmed when reading or writing a variable that is not
an array variable.
SOLUTION
Refer to the programming manual for control variables.
1505
'The variable does not allow programming an axis'
DETECTION
During execution.
CAUSE
An axis has been programmed when reading or writing a variable that is not an axis
variable.
SOLUTION
Refer to the programming manual for control variables.
1506
'Undefined label or #RPT command labels swapped'
DETECTION
During execution.
CAUSE
The possible causes are:
• The second label has not been defined.
• M30 has been programmed between the first and the second labels.
• In the #RPT instruction, the second label has been programmed first and then
the first one.
SOLUTION
Define the labels and the instruction correctly.
1507
'The second label of the #RPT must be programmed alone in the block'
DETECTION
During execution.
CAUSE
When programming the #RPT[N1,N2] instruction, the second label must be
programmed alone in the block without any other type of command. This error would
come up if N2 :X10 were programmed.
SOLUTION
The last label must be programmed alone in the block. Program the command in the
previous line to execute it with #RPT or in the next line not to execute it with the #RPT.
1508
'G201 and active C axis are not allowed on the axes of the main plane'
DETECTION
During execution.
CAUSE
The possible causes are:
1. G201 has been programmed for a C axis that is also one of the first three axes
of the channel.
2. One of the axes programmed in the #FACE instruction is in additive manual mode,
G201.
SOLUTION
The possible solutions are:
1. Program #FACE OFF so the axis stops being a C axis.
2. Program G202 #AXIS [axis] so the axis stops being in additive manual mode.
1509
'#SET AX/#CALL AX: Offset programming has no effect'
DETECTION
During execution.
CAUSE
All the axes programmed in the instruction already belonged to the current
configuration and, therefore, the instruction only means a change of order
(sequence). In this case, the programmed offset option has no effect.
SOLUTION
Check the program.
Summary of Contents for CNC8 070
