Fagor CNC8 070, Error Code List

Page: 93 / 134

CNC8070
R
EF
. 0402
E
RROR SOLUTIONS
Page 87 of 128
Errors 3000-3999
3025 'Positive software travel limit overrun'
DETECTION During execution.
CAUSE An attempt has been made to move an axis to coordinate that is beyond the software
limits. The limits may have been set by machine parameter, via program or in real time.
SOLUTION Keep the axes within the software limits.
3026 'Negative software travel limit overrun'
DETECTION During execution.
CAUSE An attempt has been made to move an axis to coordinate that is beyond the software
limits. The limits may have been set by machine parameter, via program or in real time.
SOLUTION Keep the axes within the software limits.
3027 'Error when calculating the reverse RTCP transformation'
DETECTION During execution.
CAUSE The transformation from part coordinates to machine coordinates cannot be
executed.
SOLUTION Contact your Fagor supplier.
3029 'Error when calculating the direct RTCP transformation'
DETECTION During execution.
CAUSE The transformation from machine coordinates to part coordinates cannot be
executed.
SOLUTION Contact your Fagor supplier.
3030 'Simulated axes cannot be mixed with non-simulated axes'
DETECTION During execution.
CAUSE In the process of measuring with a probe, simulated axes are being mixed with non-
simulated ones.
SOLUTION Use the same type of axes in the process of measuring with a probe.
3031'(RTCP/TLC) compensation not allowed in the current status.
DETECTION During execution.
CAUSE An attempt has been made to activate one of the RTCP or TLC compensations while
another compensation was active.
SOLUTION Execute #RTCP OFF or TLC OFF before trying to activate the desired transformation.
3032 'Home search not possible in DRO mode'
DETECTION During execution.
CAUSE An attempt has been made to home a DRO axis.
SOLUTION Do not home a DRO axis.
3033 'It is not possible to switch to manual mode if the axis is at the rotation center'
DETECTION During execution.
CAUSE An attempt has been made to activate the manual mode while the face C axis
transformation is active and the axes are in the center of rotation.
SOLUTION Activate the manual mode with the axes in a different position from that of the rotation
center.
3034 'Wrong set number
DETECTION During execution.
CAUSE An attempt has been made to access a nonexistent set of axis parameters.
SOLUTION The set number must be between 1 and NPARSET.
3035 'The difference between the following errors of slaved (coupled) axes is too
large'
DETECTION During execution.
CAUSE The following error difference between the master and the slave is greater than
MAXCOUPLE for Gantry axes or than the error programmed for coupled axes
SOLUTION Adjust similarly the dynamic performance of the axes being coupled or increase the
maximum difference allowed between the following errors of both axes.