Fagor CNC8 070, Error Code List

Page: 35 / 134

CNC8070
R
EF
. 0402
E
RROR SOLUTIONS
Page 29 of 128
Errors 1000-1999
1215 'The #CALL AX/#SET AX instruction must be programmed alone in the block'
DETECTION During execution.
CAUSE Only the block number of a label may be programmed in the same block as a "#"
instruction.
SOLUTION Check the program.
1216 '#CALL AX/#CAX: axis name being used'
DETECTION During execution.
CAUSE The name programmed in the instruction for the spindle working as C axis is already
being used by another axis of the channel.
SOLUTION
1217 '#CALL AX: index being used'
DETECTION During execution.
CAUSE The position indicated for an axis in #CALL AX is occupied by another axis.
SOLUTION Check the configuration of the axes desired for the channel, two axes cannot be in
the same position. An axis may be placed in any unoccupied position between 1 and
a number equal to the maximum number of axes plus the maximum number of
spindles allowed by the system.
1218 'The #FREE AX instruction must be programmed alone in the block'
DETECTION During execution.
CAUSE Only the block number of a label may be programmed in the same block as a "#"
instruction.
SOLUTION Check the syntax of the instruction in the manual.
1219 '"," or "]" expected'
DETECTION During execution.
CAUSE Syntax error in the instruction.
SOLUTION Check the syntax of the instruction in the programming manual.
1220 '#FREE AX: an active axis cannot be eliminated in manual mode'
DETECTION During execution.
CAUSE The axes involved in the active function G201 (additive manual) cannot be eliminated
from the channel.
SOLUTION To eliminate one of these axes, first cancel the G201 or when activating it previously
do not include this axis.
1221 'The #SET AX instruction must be programmed alone in the block'
DETECTION During execution.
CAUSE Only the block number of a label may be programmed in the same block as a "#"
instruction.
SOLUTION Check the syntax of the instruction in the manual.
1222 '#COMMENT END not expected'
DETECTION During execution.
CAUSE #COMMENT END has been programmed without programming #COMMENT
BEGIN first.
SOLUTION Check the program.
1223 'End-of-file character inside the comment block'
DETECTION During execution.
CAUSE There is a #COMMENT BEGIN block without its corresponding #COMMENT END.
SOLUTION Verify that each #COMMENT BEGIN block has its corresponding #COMMENT END
in the program.
1224 'Operator unknown or missing'
DETECTION During execution.
CAUSE In the command to write a variable or parameter, an operator is unknown or missing.
SOLUTION The valid assignment operators are "=", "+=", "-=", "*=", "/=".