Fagor CNC8 070, Error Code List

Page: 73 / 134

CNC8070
R
EF
. 0402
E
RROR SOLUTIONS
Page 67 of 128
Errors 1000-1999
1766 'SURFACE MILLING: P = 0'
DETECTION Executing the surface milling cycle.
CAUSE P (surface milling depth) programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1767 'SURFACE MILLING: L = 0 and H = 0'
DETECTION Executing the surface milling cycle.
CAUSE The two dimensions of surface milling (length and width) programmed in the cycle
are 0.
SOLUTION Set at least one of the dimensions L or H to a value greater than 0.
1768 'POINT-TO-POINT PROFILE: F = 0'
DETECTION Executing point-to-point profiling cycle.
CAUSE F for roughing, finishing or penetrating in Z programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1769 'POINT-TO-POINT PROFILE: S = 0'
DETECTION Executing point-to-point profiling cycle.
CAUSE Roughing or finishing S programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1770 'POINT-TO-POINT PROFILE: T = 0'
DETECTION Executing point-to-point profiling cycle.
CAUSE No tool T has been programmed in the cycle.
SOLUTION Assign a roughing or finishing tool T.
1771 'POINT-TO-POINT PROFILE: P = 0'
DETECTION Executing point-to-point profiling cycle.
CAUSE P (point-to-point profile depth) programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1772 'POINT-TO-POINT PROFILE: Null profile'
DETECTION Executing point-to-point profiling cycle.
CAUSE The first two points of the profile (P1 and P2) are the same and the profile is
considered to be empty.
SOLUTION Assign the coordinates of the desired points in the profile (from P1 to P12). The last
point of the profile will be the one having the next one the same.
1773 'POINT-TO-POINT PROFILE: Tool radius equal to or greater than the tangential
entry/exit radius'
DETECTION Executing point-to-point profiling cycle.
CAUSE The radius of one of the tools used in the cycle is greater than the tangential entry
radius (Radius P1) or exit radius (Radius P12) programmed in the cycle.
SOLUTION Increase the radius of the tangential entry/exit or execute the cycle with a tool of
smaller radius.
1774 'PROFILE: F = 0'
DETECTION Executing the profiling cycle.
CAUSE F for roughing, finishing or penetrating in Z programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1775 'PROFILE: S = 0'
DETECTION Executing the profiling cycle.
CAUSE Roughing or finishing S programmed in the cycle equal to 0.
SOLUTION Assign a value greater than 0.
1776 'PROFILE: T = 0'
DETECTION Executing the profiling cycle.
CAUSE No tool T has been programmed in the cycle.
SOLUTION Assign a roughing or finishing tool T.