Fagor CNC8 070, Error Code List

Page: 18 / 134

CNC8070
R
EF
. 0402
OF
128
E
RROR SOLUTIONS
Page 12 of 128
Errors 1000-1999
1028 'The difference between the programmed center and the calculated one is too
large'
DETECTION During execution.
CAUSE In a circular interpolation with function 265 active, the difference between the initial
radius and the final one exceeds the values of machine parameters CIRINERR and
CIRINFACT.
SOLUTION Program the circular interpolation correctly.
1029 'Zero radius on circular path'
DETECTION During execution.
CAUSE The probable causes are:
• A zero radius has been programmed in a circular interpolation.
• Being function G265 active, the CNC calculates a zero radius based on the center
coordinates programmed for the circular interpolation.
• Being function G265 not active, null center coordinates have been programmed
for the circular interpolation.
SOLUTION In a circular interpolation, the radius cannot be zero. Both center coordinates cannot
be null either.
1030 '#AXIS programmed without G200/G201/202'
DETECTION During execution.
CAUSE The #AXIS instruction has been programmed without programming G200/201/202
on the same line.
SOLUTION Program both functions on the same line.
1031 '#AXIS expected'
DETECTION During execution.
CAUSE Function G201 has been programmed without progromming #axis on the same line.
SOLUTION Program both functions on the same line.
1032 'Spindle position missing for M19'
DETECTION During execution.
CAUSE Function M19 has been programmed, but the spindle position has not been
programmed.
SOLUTION Check the program.
1035 '#SLOPE: parameter out of range'
DETECTION During execution.
CAUSE The value programmed for the parameter is too high.
SOLUTION Program smaller values.
1037 'Center coordinates ignored with G0/G1/G100/G63 active'
DETECTION During execution.
CAUSE It informs that the values programmed with I, J, K will be ignored.
SOLUTION These functions do not require the programming of these parameters.
1038 'Radius compensation cannot be active while measuring'
DETECTION During execution.
CAUSE An attempt has been made to execute G100 while radius compensation is active,
G41-G42.
SOLUTION Check the program.
1039 'There is a previous measurement value for the axis (axes)'
DETECTION During execution.
CAUSE An attempt has been made to do a G100 when the axis already has a measurement
offset included by a previous G101.
SOLUTION The offset included in the axis may be eliminated with function G102.