Fagor CNC 8060, Manual, Page: 53 / 148

Remote modules
CNC 8060
CNC 8065
4.
(R
EF
: 1402)
·53·
RIO5 REMOTE MODULES.
(CANOPEN
PROTOCOL).
CAN bus. ·ST· selector.
The switch position of the terminating elements must be "1" and that of the rest of the
elements "0".
·ERROR· LED. Status indicator LED.
Red LED. Its meaning depends on the blinking speed.
CAN bus. Led ·RUN·.
The LED is green. Its meaning depends on the blinking speed.
Connectors for the digital inputs and outputs.
Connector ·X4· & ·X5·. Digital outputs (8 outputs in each connector).
10-pin male Phoenix minicombicon contact (3.5 mm pitch). Both connectors must be
powered with 24 V DC and GND.
Connector ·X6· & ·X7·. Digital inputs (12 inputs in each connector).
12-pin male Phoenix minicombicon contact (3.5 mm pitch).
Line terminating resistor. The ·LT· switch identifies which are the
elements that occupy the ends of the CAN bus; i.e. the first and last
physical element in the connection.
Type of blinking. Meaning.
LED off. The module works properly.
Blinking fast. Module configuration stage.
Single blinking. Warning. Poor transmission.
Double blinking. There is no communication with the cpu.
LED on. Error. Too many errors.
Type of blinking. Meaning.
LED on. The module works properly.
Single blinking. Module stopped.
Blinking fast. Module configuration stage.
Continuous blinking. Start-up stage or error.
1
0
LT
Signal. Function.
+ 24 V Power supply.
O1 - O8 Digital outputs.
O9 - O16 Digital outputs.
GND Power supply.
O1
+24V
X4
GN D
O8
O2
O3
O4
O5
O6
O7
O9
+24V
X5
GN D
O16
O10
O11
O12
O13
O14
O15
Signal. Function.
I1 - I12 Digital inputs.
I13 - I24 Digital inputs.
I12
I1
I24
I13
X6 X7
I2
I3
I4
I5
I6
I7
I8
I9
I10
I11 I23
I22
I21
I20
I19
I18
I17
I16
I15
I14