Fagor CNC 8055, Manual

Page: 43 / 166

N
EW
F
EATURES
(S
OFT
M: 7.
XX
)
Page 39 of 50
C
NC 805
5 / CN
C 805
5i
MC model. Tool
measurement and
calibration
42 MC model. Tool measurement and calibration
Available with the "Canned cycles with Probe" option and if the
parameters that define the tabletop probe position g.m.p. PRBXMIN
(P40), PRBXMAX (P41), PRBYMIN (P42), PRBYMAX (P43),
PRBZMIN (P44) and PRBZMAX (P45) have been defined.
To access this mode, press the [F1] key. The first level corresponds
to "Tool calibration" and the second level to "Tool measurement and
calibration with a probe".
The screen for "Tool measurement and calibration with a probe" may
be saved as part of a part-program (PPROG) and shows the
following information:
In zone (1) the following may be defined:
Ds Safety distance, for the probe approach.
F Probing feedrate.
(A) Type of calibration or measurement.
• Calibrate the length or measure the tool length wear
along its shaft.
• Calibrate the length or measure the tool length wear on its
tip.
• Calibrate the radius or measure the radius wear of a tool.
•
Calibrate the radius and the length or measure the radius
and length wear of a tool.
To select the desired one, position over the desired icon and
press the (a) key.
S Tool turning speed.
Tool turning direction. Select the direction opposite to the
cutting direction.
To select the desired one, position over the desired icon and
press the (a) key.
N Number of cutting edges of the tool to be measured.
X+ In radius calibration and measurement, it indicates the
side of the probe to be used: (X+) (X-) (Y+) (Y-).
To select the desired one, position over the desired field and
press the (a) key.
(F1)
1
2
3
A
(a)