Fagor CNC 8055, Manual

Page: 161 / 166

CNC 8
0
5
5
/ CNC 8
0
5
5
i
Page 101 of 106
N
EW
F
EATURES
(S
OFT
M: 9.1
X
)
24 Status of the timer programmed with G4
TIMEG
It may be used to display the timing status of the timer programmed
with G4 K in the CNC channel.
This variable, returns the time remaining to end the timing block in
seconds.
It is read-only from the CNC, PLC and DNC.
25 Maintain the last F selected in simulation
While in simulation mode, it is possible to select the feedrate of the
axes for simulation. From now on, it will keep the last F selected.
26 Parameters accessible from the oscilloscope or OEM
program
If parameter REFVALUE, REFDIREC, FLIMIT or SLIMIT is written
from an OEM program or from the oscilloscope, it will be validated
automatically.
Parameters REFVALUE, REFDIREC and SLIMIT are assumed
immediately whereas FLIMIT will be assumed at the beginning of the
next block.
27 Controlled braking of spindle and axes via Sercos in case
of an emergency at the CNC
When an emergency occurs at the CNC, the SPENA* signals of the
axes and the spindle are disabled and the drive brakes using the
emergency ramps.
28 New coordinate variables APOS and ATPOS
These variables are equivalent to variables POS(X-C) and TPOS(X-
C) but they always show the value in part coordinates.
POS(X-C) Machine coordinates. Real of the tool base.
TPOS(X-C) Machine coordinates. Theoretical of the tool base.
APOS(X-C) Part coordinates. Real of the tool base.
ATPOS(X-C) Part coordinates. Theoretical of the tool base.