Fagor CNC 8055, Manual

Page: 107 / 166

CNC 8
0
5
5
/ CNC 8
0
5
5
i
Page 47 of 106
N
EW
F
EATURES
(S
OFT
M: 9.0
X
)
28 MC model. Selection of the reference point in rectangular
pockets and bosses.
In the simple rectangular pocket and in the rectangular boss, it may
be selected if the reference point is referred to the corner or to the
center. When associating multiple machining to a cycle, this point
indicates the position where those machining operations are applied.
It is selected with an icon.
29 MC model. Multiple machining in pockets and bosses
Any positioning cycle may be assigned to all the pockets and bosses.
• Simple rectangular, circular and pre-emptied circular pocket.
• Rectangular and circular boss
• 2D profile pocket. Pocket with island based on a profile in the XY
plane.
• 3D profile pocket. Pocket with islands with a profile in the XY plane
and up to 4 profiles with different depths.
The positioning types available are:
• Point-to-point positioning.
• Linear positioning.
• Arc positioning.
• Grid pattern positioning.
• Rectangular pattern positioning.
Pockets and bosses are associated with positioning in the same way
as the rest of the cycles (drilling, reaming, etc.).
1. Definition of the machining cycle, including the position of the
starting point.
2. Selection of the type of positioning to be associated with.
3. Programming of the different points of the positioning.
The cycle assumes as first positioning point the starting point of
the machining operation. This point may be modified when defining
the positioning.
In 2D and 3D pockets, the reference points for the positioning must
be the starting point of the outside profile.
(X,Y)
(X,Y)