Fagor CNC 8055, Manual

Page: 39 / 166

N
EW
F
EATURES
(S
OFT
M: 7.
XX
)
Page 35 of 50
C
NC 805
5 / CN
C 805
5i
MC model. Execute
a part-program
33 MC model. Execute a part-program
After accessing the list of stored part-programs and selecting the
program to be executed from the left column, it is possible to:
1. Execute the whole part-program.
Position, on the left column, over the desired program and press
(Start).
Subroutine 9998 is executed before the part-program and
subroutine 9999 after the part-program.
2. Execute a portion of the part-program.
Select the program from the left column and the operation (on the
right column) from which to begin executing the part program and
press the (Start) key.
In this case, the initial 9998 subroutine is not executed, only the
part-program and the 9999 subroutine are execute.
3. Execute the part-program starting at the first operation.
Select the program from the left column and the first operation
from the right column and press the (Start) key.
Subroutine 9998 is executed before the part-program and
subroutine 9999 after the part-program.
34 MC model. Maintain F, S y Smax on power up
MAINTASF (P162)
This g.m.p indicates whether on CNC power-up, the F, S and Smax
values are maintained or initialized.
With “MAINTASF (P162)=1”, the CNC acts as follows:
• It assumes the G94/G95 feedrate set by g.m.p. "IFEED (P14)",
but it restores the F in mm/min (G94) and the F in mm/rev (G95)
programmed last.
• It maintains the feedrate type G96/G97 used last, but it restores
the S in rev/min (G97) and the S in m/min (G96) programmed
last.
35 MC model. Messages and warnings
From this version on, some messages that come up in M mode at
the bottom of the screen over a green stripe will also come up in MC
mode. For example:
"Software limit reached"
"Zone limit reached"
36 MC model. Tool calibration
When accessing the tool calibration mode, there are a some
limitation during execution or tool inspection
Note: Programs created in ISO mode do not have subroutines
9998 and 9999.
(Start)
0 They are initialize with the values of F=0, S=0 and Smax=0
1 F, S and Smax maintain the values they had in the last
machining operation.