Fagor CNC 8055, Manual

Page: 148 / 166

N
EW
F
EATURES
(S
OFT
M: 9.1
X
)
CNC 8
0
5
5
/ CNC 8
0
5
5
i
Page 88 of 106
10 Modified variables
HARCOA It indicates, with bits, the CNC's hardware configuration. The bit will
be "1" when the relevant configuration is available.
On the 8055 model:
xxxx xxxx xxxx xx(1)(0)
HARCON It indicates, with bits, the CNC's hardware configuration.
On the 8055i model:
Bits 7, 8, 9 indicate the type of axis board.
xxxx xxx(9) (8)(7)xx xxxx
HANDSE For handwheels with axis selector button, it indicates whether that
button has been pressed or not.
This variable may be read from the CNC and from the PLC. Valid for
both axis board models.
SELPRO When having two probe inputs, it allows selecting the active probe
input.
On power-up, it assumes the value of "1" thus selecting the first probe
input. To select the second probe input, set it to a value of "2".
This variable is read-write from the CNC and PLC and read-only
through DNC. Accessing this variable from the CNC interrupts block
preparation.
ANAI(n) It returns the value of the indicated analog input (n). Its value is given
in tenth-thousandths of a volt.
On the 8055 model having the VPP axis board, it is possible to select
one of the four that are available. Accessing variables ANAI5 through
ANAI8 will issue the relevant error message.
‘Access to a variable with wrong index’.
Bit Hardware
0 Axis module 2.
1 It has a connector for compact flash.
Bit 9 Bit 8 Bit 7
1 0 1 "Axes 2" board, fe I/Os
1 1 0 "Axes 2" board, feedback only
1 1 1 "axes 2" board only I/O's
Value Meaning
0 The handwheel's axis selector button has not been
pressed.
1 The handwheel's axis selector button has been
pressed.
Value Meaning
1 It selects the first probe input.
2 It selects the second probe input.