Chapter 2 - page 6
MCO-TCO work mode
2.2 AXIS CONTROL
2.2.1
WORK UNITS
Whenever the CO work mode is accessed, the CNC assumes the work units, «mm or inches», «radii
or diameters», «millimeters/minute or millimeters/revolution», etc., that are selected by machine
parameter.
To modify these values, the "T" mode has to be accessed, modifying the relevant machine parameter.
2.2.2 COORDINATE PRESET
The axes must be preset one at a time with the following procedure:
Value
Value
The CNC requests confirmation of the command.
Press
to quit the presetting mode.
2.2.3 HANDLING THE FEEDRATE OF THE AXES (F)
To set a particular axis feedrate, proceed as follows:
Value
Press
to quit the selection.
