31
Remote access to telephone transmitter
There are two simple ways of calling the transmitter:
- just type in the number of the line to which you are
connected.
It will answer after 10 ring tones.
This time interval can be adjusted, by typing in the
#
81 xx
command on the telephone in the main menu.
(
xx
refers to the number of required tones, which can
vary from 05 to 40).
To use the second way:
- type in the telephone number, wait for one ring
tone, hang up and wait for 10 seconds.
- retype in the number within one minute. The
transmitter will answer after one ring tone.
You are connected to your
Home Shield.
Alarm ON / Alarm OFF
Maintenance Program mode
2 secs.
Alarm memory-stored / In progress
System sabotage alarm
Discharged batteries
Peripheral units fault /
Telephone line fault
Passage open signal
The second method must be used in the
following cases:
- a telephone answering system uses the same
line as the transmitter,
- the subscriber to the line signs a
subscription for a telephone message
service,
The second method is described in the
explanations in the USE chapter.
Summary of Contents for H4
Page 2: ...2...