FAAC H4, Installation And Use Instructions Manual, Page: 28 / 36

28
SIGNALS
If no control device (remote-control or control
keypad) was registered in the system, all
indicator lights flash.
MAINTENANCE PROGRAM
mode
ADD DEVICES Menu
Status of red indicator lights:
1
2
3
4
5
EFF TEST
Detector
Remote-control
Control and
information keypad
Telephone transmitter
Siren
Alarm memory-stored / In progress
Sabotage memory-stored
Sabotage in progress
except control unit
Battery fault in progress
Peripheral units fault
or telephone line fault
Perimetric fault
AP
2 secs.
Maintenance Program mode
Alarm ON / Alarm OFF
Passage open signal
Peripheral units fault /
Telephone line fault
Discharged batteries
System sabotage alarm
Alarm memory-stored / In progress
A device is present
No devices
A detector is present in the area (X)
No detectors in the area (X)
In AREA CREATION
menu
(Yellow operation
indicator light: )
In ADD DEVICES menu
(Yellow operation
indicator light: )
INDICATOR LIGHTS
To replace batteries, put the control unit in
MAINTENANCE PROGRAM mode.
„ „
Discharged batteries indication
Whenever the alarm system is enabled or disabled,
the control unit emits a series of 3 short beeps.
The time available for replacing the batteries, before
total shut-down of the system, is about 1 month.
We advise you to put the discharged batteries in the
appropriate collection bins.